Three diamonds on the bench
The live stone needs WebGL2.
The live stone needs WebGL2.
The live stone needs WebGL2.
Loupe
A 10x loupe in daylight. All three stones are diamond and look alike.
Inclusions can hint at how a stone grew. They are not proof: similar marks occur in all three, and many stones show none.
Lamp
What each test shows for each diamond
| Test | Natural | Laboratory-grown, CVD | Laboratory-grown, HPHT | What the test tells you |
|---|---|---|---|---|
| At home or at the counter | ||||
| Loupe (on the bench) | A small crystal and a feather, both formed in the earth. | A few dark pinpoints of non-diamond carbon. | A dark metallic rod: flux metal from the press. | Inclusions can hint at how a stone grew. They are not proof: similar marks occur in all three, and many stones show none. |
| Thermal pen (on the bench) | Diamond. | Diamond. | Diamond. | All diamond conducts heat much better than glass or cubic zirconia. The pen says diamond. It cannot say where the diamond grew. Moissanite also reads as diamond on a thermal pen. |
| UV torch (on the bench) | A blue glow. About 35% of natural diamonds glow, and nearly all of those glow blue. | Dark, like about 93% of near-colorless CVD stones. | Dark, like about 98% of colorless HPHT stones. | Most stones of all three origins stay dark, so no glow tells you nothing. A blue glow points to natural, but it is not proof. |
| Magnet (on the bench) | No pull. | No pull. | A slight pull toward the magnet. | A pull is a strong sign of HPHT growth: the metal inclusions respond. No pull tells you nothing, because many HPHT stones are too clean to move. |
| Inscription (on the bench) | None. Many natural diamonds carry none; some carry a report number. | LABORATORY-GROWN and a report number. | LG and a report number. | An inscription is a claim, not a test. Forged inscriptions exist on laboratory-grown stones that were cut to match natural reports. Small stones rarely have an inscription. |
| In the laboratory | ||||
| Short-wave UV (on the bench) | A weak blue, fainter than under long-wave: the usual natural order. Lamp off: Nothing: the glow stops with the lamp. | A faint green to greenish blue. Lamp off: Usually nothing. Some annealed CVD stones show a weak afterglow. | Greenish yellow, stronger than under long-wave. Lamp off: A greenish-blue afterglow, for up to a few tens of seconds. | A long greenish-blue afterglow is typical of HPHT growth. It comes from traces of boron. Low-dose irradiation can reduce or remove it. Some natural blue stones and some CVD stones also glow after. |
| Deep-UV image (on the bench) | Blue, with straight-sided growth bands from octahedral growth. | Green-blue, with fine parallel growth layers. | Blue-green growth sectors meeting in a cross. | This is the most telling picture a laboratory takes, but it needs trained eyes. Some CVD stones now show no layers and look natural. |
| Crossed polarizers (on the bench) | Weak, mottled gray strain. | Banded strain, with some color. | Almost dark: very little strain, a little round its inclusion. | Almost no strain points to HPHT growth. Natural strain and CVD strain overlap, so this test cannot tell those two apart. |
| Infrared (on the bench) | Nitrogen in clusters at 1282 and 1175: type Ia. | No nitrogen: type IIa. | A trace of boron at 2800: weak type IIb. | Nitrogen in clusters (type Ia) clears about 99% of natural colorless diamonds. All colorless laboratory-grown stones are type II, but about 1% of natural stones are type II too. Type II means: test further. |
| Photoluminescence (on the bench) | A strong line at 415 nm (N3), from nitrogen clusters. | The silicon pair at 737 nm, 503 nm from the annealing, a trace of 415 nm. | Few lines. This stone shows a weak nickel pair near 883 and 884 nm, as about 30% of colorless HPHT stones do. | No single line is proof, because each line also occurs, rarely, in the other kinds. The laboratory reads the full set, with several lasers. |
| Screening device (on the bench) | Pass. | Refer for further testing. | Refer for further testing. | Pass means natural. Refer means test further: laboratory-grown stones, simulants and some natural diamonds all get Refer. In independent tests, devices referred from under 1% to about 14% of natural stones. |
A model of three typical stones. It is not a test of a real stone. Only a gemological laboratory can find where a diamond grew. How the bench is modeled, with the sources.
The Polariscope shows strain in a diamond between crossed polarizers. The Spectroscope shows the dark lines of seven gemstones in visible light.